Tech Support

3460 Series TechNotes This page supports these models: 3460, 3560, 3564 3470, 3570, 3574 3480, 3480+, 3580, 3580+ 3470-24 3460: 3560: 3564: 3470: 3570: 3574: 3480: 3480+: 3580: 3580+: Introduced Apr 1995 Mar 1996 Nov 1998 Jun 1996 Jun 1996 Nov 1998 Apr 1995 Dec 1998 Mar 1996 Dec 1998 End of Life Oct 2000 Oct 2000 Oct 2000 Oct 2000 Oct 2000 Oct 2000 Dec 1998 Dec 1998       ABOUT TECHNOTES TechNotes Quick Index General       Windows Printing       IBM Connectivity       Page Printers       Intelliprint Page Printers 3460 Series Tech Notes 3V-001 3400 Series Initialize Procedure How and when to initialize the 3400 Series printer. 3V-002 Sensor Tune Procedure Tuning the paper sensors to the ambient light in the room. 3V-003 Changing Firmware Procedure and safety precautions for installing firmware upgrades. 3V-004 Firmware for Windows support Firmware upgrade for Windows support. 3V-005 3400 Series Bail Assembly Damage The mylar paper clamp on the bail assembly is damaged.  Paper jams against the white plastic paper clamp. 3V-006 Paper Moves Forward When Parking When parking the paper, the paper moves forward instead of reversing into the tractors 3V-008 3480 EPSON or IBM Barcode Problems User programmed bar codes in Epson or IBM emulation do not print properly. 3V-012 Margin Settings Greater Than Two Inches Setting a top and bottom margin greater than two inches on 34xx and 35xx printers can be achieved with a bit of trickery. 3V-013 Default Paper Path v.s. SIMS Command Default Paper Path v.s. SIMS Command 3V-014 3500 Models - Windows Drivers The IBM interface requires that the printer be set to the IBM emulation. 3V-015 3500 Models - Twinax / Coax Status Printout 3500 Models - Twinax / Coax SCS Interface Board Status Printout 3V-016 Panel Display Shows "Black Boxes" New Printer displays "black boxes" in LCD display on initial power up. 3VA-001 Reverse Paper Motion During Printing The 3460 / 3480 printers will perform a reverse paper motion in the rear paper path during printing of the first page. 3VB-001 Interlock Error "INTERLOCK ERROR...CHECK INSERTION" is displayed at power on, particularly just after having installed firmware 44A513932 (3460) or 44A513933 (3480). About TechNotes:   TallyGenicom has taken care to ensure that the information is complete, accurate and up-to-date. However, TallyGenicom assumes no responsibility for errors or omissions which may occur. All the information provided is subject to change from time to time at the sole discretion of TallyGenicom. This information is provided "as is" without warranty of any kind. TallyGenicom disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall TallyGenicom, or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if TallyGenicom, or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion or limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.

Specifications subject to change without notice. ® All trademarks are property of their respective holders at the time of this publication. If you have any questions or comments regarding this document, please contact TallyGenicom Technical Support. Copyright © 2000 — TallyGenicom