Tech Support

microLaser 200 Flash Code This page supports these models:  microLaser 200   Introduced: May 98 Discontinued: Nov 99 Replaced by: microLaser 280 System Image Flash Instructions - Download the system image file. - Unzip the file- it will contain the image file and the PORT utility. - Turn the printer power off. - Press and hold any two keys. - Turn the power on. - The display shows DOWNLOAD IMAGE. - Ensure the printer is connected parallel to the PC. - Open a DOS prompt and navigate to the folder where the system file was unzipped to. - Send the system image file: PORT <filename> - The printer will show LOADING FLASH IMAGE, then WRITING FLASH IMAGE. - When complete, the printer will reboot and print a startup page. mL200 Printer System Image Code ml200_flash_102 System Image File in PostScript Format (.PS) Version: 1.0.2 Size: 5.1 M For parallel or network transfer- use for upgrades. ml200_100_dl System Image File in DownLoad Format (.DL) Version: 1.0 Size: 4.4 M For parallel transfer only. Use for printers with corrupt boot code. Network Interface Image Flash Instructions - Download the network image file. - Unzip the file- it will contain the image file. - Open a ftp session and put the file: ftp 10.1.3.111 user: password: binary hash put en549tb.ps - The printer will show LOADING FLASH IMAGE, then WRITING FLASH IMAGE. - When complete, the printer will reboot and print a startup page. Network Interface Image File mlq_nic_549tb Network Flash for Integrated Interface (10BaseT/2) Version: 5.49TB Size: 484 K mlq_nic_fe_544.exe Network Flash for Fast Ethernet Option (100BaseT) Version: 5.44 Size: 457 K

Specifications subject to change without notice. ® All trademarks are property of their respective holders at the time of this publication. If you have any questions or comments regarding this document, please contact TallyGenicom Technical Support. Copyright © 2000 — GENICOM,