4000 Series Remote Select / Deselect

TechNote 40T-035

4000 Series

4000 Series Remote Select / Deselect
5-3-91 Pat Hennigan

Models: 4000 Series

Summary:
Jumper settings to allow a DC1 / DC3 (decimal 17 / 19 ) to select and / or deselect a 4000 series printer

Resolution:



To allow a DC1 / DC3 (decimal 17 / 19 ) to select and / or deselect a 4000 series 
 printer remotely while in parallel interface you need to change the following:

1. Change jumper on SMPI board from J45 to J46. Online / Local status will not 
   be reflected in BUSY.

2. Set interface strap A5=1. Online / Local status will not be reflected in FAULT.

Specifications subject to change without notice.
® All trademarks are property of their respective holders at the time of this publication.

If you have any questions or comments regarding this document, please contact
TallyGenicom Technical Support.

TallyGenicom has taken care to ensure that the information is complete, accurate and up-to-date. However, TallyGenicom assumes no responsibility for errors or omissions which may occur. All the information provided is subject to change from time to time at the sole discretion of TallyGenicom. This information is provided "as is" without warranty of any kind. TallyGenicom disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall TallyGenicom, or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if TallyGenicom, or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion or limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.