Intermittant "rJ" Errors

TechNote 40U-005

4410 / 4440 Series

4410 / 4440 XT Intermittant "rJ" Errors

Models: 4410, 4440

Summary:
Printer will intermittantly display "rJ" and stop printing. This occurs on printers
using A514500/501 firmware and A514380 fonts.

Resolution:


CAUSE:  Timer in the system firmware should reset each time a full lap of ribbon 
cloth is cycled. Weld detector and SUS mode should cause the reset of the rJ timer.

ACTION: Install Printer Control Strap B13 (45). This will disable ribbon weld detection.

Specifications subject to change without notice.
® All trademarks are property of their respective holders at the time of this publication.

If you have any questions or comments regarding this document, please contact
TallyGenicom Technical Support.

TallyGenicom has taken care to ensure that the information is complete, accurate and up-to-date. However, TallyGenicom assumes no responsibility for errors or omissions which may occur. All the information provided is subject to change from time to time at the sole discretion of TallyGenicom. This information is provided "as is" without warranty of any kind. TallyGenicom disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall TallyGenicom, or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if TallyGenicom, or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion or limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.