TechNote  40U-036

4410 / 4440  Series

4410 / 4440 XT Hybrid

Models:

Summary:
In the fall of 1992, a limited number of printers were produced that were a hybrid between the XT and XT+ models.


Resolution:


In the fall of 1992, a limited number of printers were produced that were a hybrid 
between the XT and XT+ models.  When the configuration is printed, the first line 
will show:

THE PRESENT CONFIGURATION IS: (ASIC with SMPI  44A513820 SY - 44A513821 IS)

- This model has the following logic boards:
	SMPI
	SMSM with SMSI
	SMIS
	SMMC

- 44A513820 / 44A513821 is the *only* fimware released for this model.

- This printer has the IBM ProPrinter emulation.  It does NOT have compressed POSTNET 
  barcodes.

- To upgrade the firmware, the SMPI and SMSM boards must be replaced with a SPER, and 
  the 4440XT+ firmware must be installed.





Specifications subject to change without notice.
® All trademarks are property of their respective holders at the time of this publication.

If you have any questions or comments regarding this document, please contact

TallyGenicom Technical Support.



TallyGenicom has taken care to ensure that the information is complete, accurate and up-to-date. However, TallyGenicom assumes no responsibility for errors or omissions which may occur. All the information provided is subject to change from time to time at the sole discretion of TallyGenicom. This information is provided "as is" without warranty of any kind. TallyGenicom disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall TallyGenicom, or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if TallyGenicom, or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion or limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.