TechNote mL400-02
microLaser 400
Cleaning the Erase Lamp Assembly
18 Sep 2000 Ed Palmer

Summary: The Erase Lamp should be cleaned when the Drum is replaced, or when print quality is unacceptable.

Procedure:

  • Remove the Drum and store it in a light proof container. Refer to GEK-89470, microLaser 400 Operations, page 45.
  • Locate the Erase Lamp Assembly.

  • Using a soft cloth (included with a new Drum Unit), clean the Erase Lamp.
  • Clean any toner elsewhere in the printer.
  • Re-install the Drum.

A toner vacuum is useful in cleaning toner- refer to TechNote Page-01.

Prevention:

  • Toner dumping is commonly caused by not replacing the Toner Waste Bottle. Refer to TechNote mL400-03.

Copyright © 2000 GENICOM,

Specifications subject to change without notice.
® All trademarks are property of their respective holders at the time of this publication.


If you have any questions or comments regarding this document, please contact TallyGenicom Technical Support.
TallyGenicom has taken care to ensure that the information is complete, accurate and up-to-date. However, GENICOM assumes no responsibility for errors or omissions which may occur. All the information provided is subject to change from time to time at the sole discretion of GENICOM. This information is provided "as is" without warranty of any kind. GENICOM disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall GENICOM, or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if GENICOM, or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion or limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.