TechNote mL400-05
microLaser 400
Printing Stops
29 Sep 2000 Ed Palmer

Summary: The printer stops printing. The hard drive icon on the display is lit, indicating spooled data.

Cause: Toner dumping in the transfer charger, inducing noise on the data bus thus disconnecting the hard drive.

Resolution:

Prevention:


Copyright © 2000 GENICOM,

Specifications subject to change without notice.
® All trademarks are property of their respective holders at the time of this publication.


If you have any questions or comments regarding this document, please contact
TallyGenicom Technical Support.


TallyGenicom has taken care to ensure that the information is complete, accurate and up-to-date. However, GENICOM assumes no responsibility for errors or omissions which may occur. All the information provided is subject to change from time to time at the sole discretion of GENICOM. This information is provided "as is" without warranty of any kind. GENICOM disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall GENICOM, or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if GENICOM, or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion or limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.