Summary: A printer is attached to Windows NT host via a LPR Port. There may be delays between jobs, or jobs may not print.

Cause: Windows NT only allows eleven TCP ports to be in use by the LPR service at one time. A port cannot be reused for a minimum of four minutes.

Solution: Configure Windows NT to use more TCP ports.

For Windows NT 4.0 SP3 and above, refer to Microsoft KB Article 179156

For Windows NT 3.51 and above, refer to Microsoft KB Article 153666

Copyright © 2002 GENICOM, Specifications subject to change without notice. ® All trademarks are property of their respective holders at the time of this publication. If you have any questions or comments regarding this document, please contact TallyGenicom Technical Support. TallyGenicom has taken care to ensure that the information is complete, accurate and up-to-date. However, GENICOM assumes no responsibility for errors or omissions which may occur. All the information provided is subject to change from time to time at the sole discretion of GENICOM. This information is provided "as is" without warranty of any kind. GENICOM disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall GENICOM, or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if GENICOM, or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion or limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.